RRP 8.3 Duplex Interface Board
(See
PL 11.1 500-Sheet Feeder (1 of
Figure 97 Duplex Interface Board
Removal
Caution: These components are susceptible to electrostatic
discharge. Observe all ESD procedures to avoid damage.
Warning: Switch off the power and disconnect the Power Cord.
1.
Remove the Rear Cover (RRP 1.9 Rear Cover).
2.
Remove the HVPS Cover (RRP 1.6 HVPS Cover).
3.
DIsconnect P/J501, P/J504, and P/J506 from the Duplex Interface PWB.
4.
Remove the two screws that secure the Duplex Interface PWB to the printer.
5.
Remove the Duplex Interface PWB.
Replacement
Reinstall the components in the reverse order.
308
3))
Phaser 5400 Laser Printer Service Guide