Symptoms And Solutions - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Symptoms and Solutions

Symptoms and Solutions

Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
6-24
Have the same address jumpers, terminators, and cabling
•
Have the same software versions and levels
•
Have the same diagnostics code
•
Have the same configuration options set in the system
•
Have the same setup for the operating system control files
•
Comparing the configuration and software setup in working and nonworking
systems might help to resolve the problem.
This section lists symptoms, errors, and the possible causes. The most likely cause
is listed first. Use this symptom-to-solution index to help you decide which
components your service representative needs to have available when servicing
the system.
The first column of the three-column tables in this section lists the error code or
message, the second column describes the error, and the third column lists one or
more suggested actions or components that need to be reseated or replaced. Use
the table to identify possible causes for the error message and then call your
service representative.
The POST BIOS code displays POST error codes and messages on the screen.
This section includes the following topics:
Beep Symptoms, page 6-25
•
No Beep Symptoms, page 6-29
•
System Error LED and the Diagnostic Panel LEDs, page 6-30
•
Diagnostic Error Codes, page 6-33
•
Error Symptoms, page 6-40
•
• POST Error Codes, page 6-49
Chapter 6 Troubleshooting the System Hardware
OL-15012-02