Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual page 60

Replacing a Power Supply
Figure 4-10 Replacing a Power Supply
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
4-16
Chapter 4
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact a
service technician.
To replace a power supply, complete the following steps:
Disconnect the power cord from the AC power supply that you are removing.
1.
Grasp the power supply handle.
2.
Press the orange release latch down and hold it down.
3.
Pull the power supply part of the way out of the bay, as shown in
4.
Release the release latch. Support the power supply underneath and pull it the
5.
rest of the way out of the bay.
Installing Hardware Options for the WAE-7371, WAE-7341, and WAE-674
Hot-swap
power supply
Power supply
release lever
Power supply
handle
Figure 4-10.
OL-15012-02