Using Power Protection Devices; Surge Protectors - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Appendix B Maintaining the Wide Area Application Engine

Using Power Protection Devices

Surge Protectors

OL-15012-02
Teletype machines
–
Adding machines
–
Laser printers
–
Facsimile machines
–
Any other motorized equipment
–
Besides these appliances, the greatest threats to a system's supply of power are
surges or blackouts caused by electrical storms. Whenever possible, turn off the
system and any peripherals and unplug them from their power sources
during thunderstorms.
If a blackout occurs—even a temporary one—while the system is turned on, turn
off the system immediately and disconnect it from the electrical outlet. Leaving
the system on may cause problems when the power is restored; all other
appliances left on in the area can create large voltage spikes that can damage
the system.
A number of devices are available that protect against power problems such as
power surges, transients, and power failures. The following subsections describe
some of these devices:
• Surge Protectors, page B-7
Line Conditioners, page B-8
•
Uninterruptible Power Supplies, page B-8
•
Surge protectors are available in a variety of types and usually provide a level of
protection commensurate with the cost of the device. Surge protectors prevent
voltage spikes, such as those caused during an electrical storm, from entering a
system through the electrical outlet. Surge protectors, however, do not offer
protection against brownouts, which occur when the voltage drops more than
20 percent below the normal AC line voltage level.
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
Using Power Protection Devices
B-7