Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual page 36

Installing the Wide Area Application Engine
Align the slide rail with the front mounting flange. Use the score mark on the slide
Step 2
rail (labeled 1 in
latch to close the latch and secure the slide rail. Do the same for the front of the
other slide rail. Align the slide rail with the rear mounting flange. The slide rail
occupies the full height of the device. Close the latches to secure the rear of both
the slide rails.
Note
Figure 3-3
1
Extend the slide rails fully from the rack until the slide rails lock. Align the tabs
Step 3
on the slide rails (labeled 1 in
appliance and lower the appliance onto the slide rails.
Note
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
3-6
Figure 3-3) to align the slide rail. Push outward on the slide rail
Make sure that the slide rails are securely seated on the mounting flanges.
When the slide is secure, the slide rail pins protrude from the slide rails.
Aligning the Slide Rails
2
1
Slide rail score mark
Make sure that each slide rail tab is inserted in the matching insert on the
appliance and that the appliance is resting on the top edge of the slide rail.
Chapter 3 Installing the Wide Area Application Engine
2
Slide rail pins
Figure 3-4) with the matching inserts on the
OL-15012-02