Inline Network Adapter Cabling Requirements - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Chapter 5 WAE Inline Network Adapter
Table 5-2 Inline Network Adapter Specifications (continued)
Specification
Data transfer rate
General Technical Specifications
Interface standard
Size
PCI connector
PCI voltage
Weight
Operating humidity
Operating temperature
Storage temperature

Inline Network Adapter Cabling Requirements

OL-15012-02
Description
1000-Mbps, 100-Mbps, and 10-Mbps speeds per port in
half-duplex mode
2000-Mbps, 200-Mbps, and 20-Mbps speeds per port in
full-duplex mode
PCI v2.2 32/64 bit, 33/66 MHz
PCI-X v1.0 32/64 bit, 66/100/133 MHz
6.6 x 4.2 in. (167.64 x 106.68 mm)
Universal 64-bit connector
+12 V (minimum 11.4 V, maximum 12.6 V)
+3.3 V (minimum 3.0 V, maximum 3.6 V)
6.18 oz (175 g)
0 to 90%, noncondensing
32 to –122
–4 to –149
The inline network adapter ships with two types of cables: crossover and
straight-through. When you connect the WAE inline network adapter, the cable
that you use depends on the link speed (Gigabit Ethernet or Fast Ethernet) and the
types of devices (DCE or DTE) being connected.
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
Inline Network Adapter Cabling Requirements
o o
F (0 to 50 C)
o o
F (–20 to –65 C)
5-5