Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual page 124

Symptoms and Solutions
Table 6-20 POST Error Codes (continued)
Error Code Symptom
151 Real-time clock error.
161 Real-time clock battery error.
162 Device configuration error.
163 Real-time clock error (time of day
not set).
175 Hardware error.
184 Power-on password damaged.
187 VPD serial number not set.
189 An attempt was made to access the
device with invalid passwords.
289 DIMM disabled by POST or user.
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
6-50
Chapter 6 Troubleshooting the System Hardware
Cause and Action
Check the battery.
1.
Check the system board.
2.
Check the battery.
1.
Check the system board.
2.
Run the Configuration/Setup Utility program,
1.
choose Load Default Settings, and save the
settings.
Check the battery.
2.
Check for failing device.
3.
Check the system board.
4.
Run the Configuration/Setup Utility program,
1.
choose Load Default Settings, make sure that
the date and time are correct, and save the
settings.
Check the battery.
2.
3. Check the system board.
Check the system board.
Restart the device and enter the administrator
1.
password; then, run the Configuration/Setup
Utility program, choose Load Default
Settings, and save the settings.
Check the battery.
2.
Check the system board.
3.
Check the system board.
Check your passwords.
Check for a disabled DIMM, if not disabled by
the user.
OL-15012-02