Diagnostic Panel Leds - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Chapter 6 Troubleshooting the System Hardware

Diagnostic Panel LEDs

Table 6-3 Diagnostic Panel LEDs
Diagnostic Panel LED
OVER SPEC
PS1
OL-15012-02
To view the Light Path Diagnostics panel, slide the latch to the left on the front of
the operator information panel and pull the panel forward to reveal the Light Path
Diagnostics panel. Lit LEDs on this panel indicate the type of error that has
occurred. Note any LEDs that are lit, and then push the Light Path Diagnostics
panel back into the device.
Look at the system service label on the top of the device, which gives an overview
of internal components that correspond to the LEDs on the Light Path Diagnostics
panel.
Figure 6-2 shows the LEDs on the diagnostic panel inside the device. See
Table 6-8 on page 6-30
LEDs.
Figure 6-2 Diagnostic Panel LEDs
OVER SPEC
CPU
REMIND
MEM
SP
FAN
PCI
The Light Path Diagnostics LEDs are described in
Description
The power supplies are using more power than their maximum rating.
The power supply in bay 1 failed.
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
Identifying Problems Using Trouble Indicators and Status LEDs
for information about identifying problems using these
Light Path
Diagnostics
PS1 PS2
VRM CNFG
NMI S ERR
DASD RAID
TEMP BRD
Table 6-3.
6-17