Installing Memory In A Wae-674 - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Installing Memory in a WAE-674

Figure 4-8
Align each DIMM so that the key fits correctly with the connector.
Step 8
Insert each DIMM into the connector. Firmly press the DIMM straight down into
Step 9
the connector so that the retaining clips snap into the locked position.
Note
Step 10 Replace the DIMM air baffle.
Replace the riser-card assembly.
Step 11
Reinstall the cover.
Step 12
For instructions on completing the hardware installation, see the
Installation" section on page
Once the hardware installation has been completed, you must repartition the
Step 13
disks, using the disk delete-data-partitions command, and reload.
Note
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
4-12
Chapter 4 Installing Hardware Options for the WAE-7371, WAE-7341, and WAE-674
Inserting a DIMM into the slot
If there is a gap between the DIMM and the retaining clips, the DIMM is
not correctly inserted.
4-8.
Repartitioning the disks is required after adding memory to reset the DRE
space allocation.
"Completing the
OL-15012-02