Installing Memory In A Wae-674 - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Chapter 4 Installing Hardware Options for the WAE-7371, WAE-7341, and WAE-674
Caution
Step 3

Installing Memory in a WAE-674

Step 1
Step 2
Step 3
Step 4
OL-15012-02
Do not leave open spaces above or below an installed device in the rack cabinet.
To help prevent damage to device components, always install a blank filler panel
to cover the open space and to help ensure proper air circulation. See the
documentation that comes with your rack cabinet for more information.
Connect the cables and power cords. For information on connecting cables and
power cords, see the "Connecting Cables" section on page
The WAE-674 features 4 GB of RAM. You can install an additional 4 GB of RAM
to give your WAE-674 a total of 8 GB of RAM. This section describes how to
install the optional 4 GB memory upgrade, which includes two 2-GB DIMMs.
To install additional memory in your WAE-674, follow these steps:
Review the information in the
"Safety Guidelines" section on page
Power off the device and all attached devices and disconnect all external cables
and power cords.
Remove the device top cover. See the
Remove the riser-card assembly as shown in
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
Installing Memory in a WAE-674
"Safety Warnings" section on page 2-1
2-4.
"Removing the Cover" section on page
Figure 4-6.
3-11.
and the
4-1.
4-9