Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual page 50

Working with Adapters
Figure 4-3
Connect any needed cables to the adapter.
Step 8
When you route cables, do not block any connectors or the ventilated space
Caution
around any of the fans.
Make sure that cables are not routed on top of components under the PCI-X
riser-card assembly.
Make sure that cables are not pinched by the device components.
Carefully align the riser-card assembly with the release tab posts, the guides on
Step 9
the rear of the WAE, and the riser-card connector on the system board. Press down
on the assembly. (See
seated in the riser-card connector on the system board.
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
4-6
Chapter 4 Installing Hardware Options for the WAE-7371, WAE-7341, and WAE-674
Installing the Adapter in the Riser-Card Assembly
Inverted riser assembly
Figure 4-4.) Make sure that the riser-card assembly is fully
OL-15012-02