Installing The Chassis On A Tabletop - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Installing the Wide Area Application Engine
Step 8
Note

Installing the Chassis on a Tabletop

Step 1
Step 2
Step 3
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
3-10
Slide the WAE into the rack until the release latches lock into place. To slide the
WAE out of the rack, press the release latches.
Insert the optional M6 screws (labeled 10 in
the appliance when moving the rack, or if you install the rack in a vibration-prone
area.
To remove the WAE from the rack, reverse these instructions. Store these
installation instructions with your WAE documentation for future use.
When you install a WAE on a workbench or tabletop, ensure that the surface is
clean and in a safe location and that you have considered the following points:
The chassis should be installed off the floor. (Dust that accumulates on the
•
floor is drawn into the interior of the chassis by the cooling fans. Excessive
dust inside the WAE can cause overtemperature conditions and component
failures.)
There must be approximately 19 inches (48.26 cm) of clearance at the front
•
and rear of the chassis for accessing network cables or equipment.
The WAE will receive adequate ventilation (it is not being installed in an
•
enclosed cabinet where ventilation is inadequate).
To install the WAE on a workbench or tabletop, follow these steps:
Remove any debris and dust from the tabletop or workbench, as well as from the
surrounding area. Also make sure that your path between the WAE and its new
location is unobstructed.
Attach the rubber feet to the bottom of the chassis. The rubber feet have an
adhesive backing. Peel the protective tape off the adhesive and stick the feet to the
bottom of a clean chassis surface. Place one foot in each corner.
Place the chassis on the tabletop or workbench.
Chapter 3 Installing the Wide Area Application Engine
Figure 3-1) in the front and rear of
OL-15012-02