Post Error Codes - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Chapter 6 Troubleshooting the System Hardware
Table 6-19 Software Problems
Symptom
Suspected software problem.

POST Error Codes

Table 6-20 POST Error Codes
Error Code Symptom
062 Three consecutive startup failures
using the default configuration.
101, 102 System and processor error.
106 System and processor error.
OL-15012-02
Cause and Action
1. To determine if problems are caused by the software, verify the
following items:
Your device has the minimum memory needed to use the
a.
software. For memory requirements, see the information that
comes with the software.
If you have just installed an adapter or memory, you might
Note
have a memory address conflict.
The software is designed to operate on your device.
b.
Other software works on your device.
c.
d. The software that you are using works on another device.
If you received any error messages when using the software
2.
program, see the information that comes with the software for a
description of the messages and suggested solutions to the
problem.
In the error codes in Table
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
6-20, X can be any number or letter.
Cause and Action
Run the configuration/setup utility program.
1.
Check the battery.
2.
Check the microprocessor.
3.
Check the system board.
4.
Check the system board.
Check the system board.
Symptoms and Solutions
6-49