Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual page 110

Symptoms and Solutions
Table 6-9 Error Code Definitions (continued)
Error Code Problem
089-XXX-00n Failed microprocessor test.
n = APIC ID for failing
microprocessor:
•
•
166-250-000 System Management: Failed.
I2C cable is disconnected.
166-400-000 System Management: Failed.
BMC self-test failed.
166-404-001 System Management: Failed.
BMC indicates failure in I2C bus
test.
166-406-001 System Management: Failed.
BMC indicates failure in I2C bus
test.
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
6-36
0, 1, 2, 3 = microprocessor 1
4, 5, 6, 7 = microprocessor 2
Chapter 6 Troubleshooting the System Hardware
Action
Check the microprocessor.
Check the I2C cable between the operator
1.
information panel assembly and the system
board.
Check the system board.
2.
Reflash or update firmware to the latest
1.
level.
Check the system board.
2.
Disconnect all power cords and external
1.
cables from the device, wait 30 seconds,
reconnect, and retry.
Reflash or update firmware to the latest
2.
level.
Reseat the power backplane.
3.
Check the system board.
4.
Disconnect all power cords and external
1.
cables from the device, wait 30 seconds,
reconnect, and retry.
Reflash or update firmware to the latest
2.
level.
Reseat the hard disk drive signal cable and
3.
backplane.
Check the system board.
4.
OL-15012-02