Installing An Adapter - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Working with Adapters

Installing an Adapter

Step 1
Step 2
Step 3
Step 4
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
4-4
Chapter 4
PCI slots 1, 2, 3, and 4.
–
For information about the features of the Cisco WAE Inline Network Adapter and
its cabling requirements, see
To install a PCI-X adapter in the riser-card assembly, follow these steps:
Review the information in the
"Safety Guidelines" section on page
Power down the device and peripheral devices and disconnect all power cords and
external cables.
Remove the cover. (See the
Remove the PCI-X riser-card assembly. (See
assembly release tabs toward the PCI-X slots. Grasp the assembly at the rear and
side edges and lift it to remove it from the WAE. Place the riser-card assembly on
a flat, static-protective surface.
Installing Hardware Options for the WAE-7371, WAE-7341, and WAE-674
Chapter 5, "WAE Inline Network Adapter."
"Safety Warnings" section on page 2-1
2-4.
"Removing the Cover" section on page
Figure 4-2.) Push the two riser-card
and the
4-1.)
OL-15012-02