Network Cabling Specifications; Console Port Considerations; Eia/Tia-232 - Cisco 1000 Series Hardware Installation Manual

Prepare for Router Installation
Table 6: Power Requirements for Cisco 1000 Series Integrated Services Router
Power Source
66W AC Power Adapter
(PWR-66W-AC-V2)
115W AC Power Adapter
(PWR-115W-AC)
30W AC Power Adapter
(PWR-30W-AC)
150W AC Power Adapter
(PWR-150W-AC)
66W DC Power Adapter
(PWR-66W-I-DC)

Network Cabling Specifications

The following sections describe the cables and the specifications required to install Cisco 1000 Series Integrated
Services Router:

Console Port Considerations

The router includes an asynchronous serial console port. The console ports provide access to the router using
a console terminal connected to the console port. This section discusses important cabling information to
consider before connecting the router to a console terminal or modem.
Console terminals send data at speeds slower than modems do; therefore, the console port is ideally suited
for use with console terminals.

EIA/TIA-232

Depending on the cable and the adapter used, this port appears as a DTE or DCE device at the end of the
cable. Only one port can be used at the same time.
The default parameters for the console port are 9600 baud, 8 data bits, 1 stop bit, and no parity. The console
port does not support hardware flow control. For detailed information about installing a console terminal, see
the Connecting to a Console Terminal or Modem section.
For cable and port pinouts, see the Cisco Modular Access Router Cable Specifications document located on
Cisco.com.
Input Rated
100-240V, 2A
100-240VAC, 2A, 50-60 Hz
100-240 VAC, 1A
100-240 VAC, 2A
24 V DC Nominal (19.7V DC to
30 V DC input range)
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
Network Cabling Specifications
Output Rated
12 VDC, 5.5A
12V, 4.6A, -53.5V 1.12A
12V , 2.5A
12V 5.5A, -53.5 1.5A
12 VDC, 5.5A
27