Package Contents; Installing The Chassis In The Rack - Cisco IPS 7.1 Installation Manual

Installing and Removing the Slide Rail Kit

Package Contents

The slide rail kit package contains the following items:
•
•
•

Installing the Chassis in the Rack

To install the chassis in the rack using the slide rail kit, follow these steps:
Press the latch on the end of the slide rail and push forward to engage the pins in the rack until the clip
Step 1
clicks and locks around the rack post
Note
Figure 7-8
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
7-22
Left and right slide rails
Six #10-32 screws
Two #10-32 cage nuts
The slide rails are labeled 'left' and 'right.' Install the left slide rail on the left side of the rack
and the right slide rail on the right side of the rack.
Press and Push to Install the Slide Rail
Chapter 7
(Figure 7-8).
Installing the IPS 4510 and IPS 4520
OL-24002-01