Power Off The Device Using Fdm - Cisco Firepower 1010 Getting Started Manual

Power Off the Device Using FDM

Example:
firepower login: admin
Password:
Last login: Thu May 16 14:01:03 UTC 2019 on ttyS0
Successful login attempts for user 'admin' : 1
firepower#
Step 2 Access the FTD CLI.
connect ftd
Example:
firepower# connect ftd
>
After logging in, for information on the commands available in the CLI, enter help or ?. For usage information,
see the
Step 3
To exit the FTD CLI, enter the exit or logout command.
This command returns you to the FXOS CLI prompt. For information on the commands available in the FXOS
CLI, enter ?.
Example:
> exit
firepower#
Power Off the Device Using FDM
You can shut down your system properly using FDM.
Procedure
Step 1 (6.5 and later) Use FDM to shut down the device.
Note
a) Click Device, then click the System Settings > Reboot/Shutdown link.
b) Click Shut Down.
Step 2
Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit).
Step 3 After the chassis has successfully powered off, you can then unplug the power to physically remove power
from the chassis if necessary.
Cisco Firepower 1010 Getting Started Guide
56
Cisco Firepower Threat Defense Command
For 6.4 and earlier, enter the shutdown command at the FDM CLI.
Firepower Threat Defense Deployment with CDO
Reference.