Configure Opentrunking; Configure Panel (Security Page With Efm Tab) - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 Installation And Service Manual

Figure 2-103
Configure
OpenTrunking

Configure Panel (Security Page with EFM Tab)

2. Perform one of the following steps as required:
• Click Enable to activate EFM. The message Your changes to
enterprise fabric mode have been successfully activated
appears.
• Click Disable to deactivate EFM. The message Your changes to
enterprise fabric mode have been successfully activated
appears.
Perform this procedure to configure OpenTrunking parameters. The
OpenTrunking feature must be installed to access this control. Refer
to Install PFE Keys (Optional)
feature is not installed, the message OpenTrunking Feature Not
Installed appears. To configure OpenTrunking parameters:
1. At the Configure panel, click the Performance tab. The Performance
page displays with the OpenTrunking tab selected
page 2-130).
Task 25: Configure the Switch from the SANpilot Interface (Optional)
on page 2-132 for instructions. If the
Installation Tasks
(Figure 2-104 on
2-129
2