McDATA 316095-B21 - StorageWorks Edge Switch 2/24 Installation And Service Manual page 437

R
Message
Description
Action
Message
Description
Action
Message
Description
Action
S
Message
Description
Action
R_A_TOV must be greater than E_D_TOV.
R_A_TOV must be greater than E_D_TOV.
Change one of the values so that R_A_TOV is greater than E_D_TOV.
Resource is unavailable.
The specified operation cannot be performed because the product is
unavailable.
Verify that the EFC Server-to-product link is up. If the link is up, the
EFC Server may be busy. Try the operation again later.
Preferred Paths can not be enabled until the Domain ID is set to
Insistent. Disable Preferred Paths, then configure Switch
Parameters.
If the switch's domain ID has not been set to Insistent, the user is not
allowed to activate the Preferred Path configuration with the Enable
Preferred Paths check box selected.
Close the Configure Preferred Paths dialog box and select the Configure
menu, then Operating Parameters, then Switch Parameters. On the
Configure Switch Parameters dialog box, select the Insistent check box.
Send firmware failed.
Send firmware operation has failed.
Retry the operation. If the condition persists, contact support
personnel.
Sphereon 3032/3232 Element Manager Messages
Messages
A
A-27