Chapter 5 Fru Removal And Replacement; Remove And Replace Frus; Frus; Esd Requirements - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 Installation And Service Manual

Remove and Replace FRUs

FRUs

ESD Requirements

Table 5-1
SFP LC transceiver
Power supply
Cooling fan
This chapter describes the removal and replacement procedures
(RRPs) for the Sphereon 3032/3232 field-replaceable units (FRUs). Do
not remove a FRU until a failure is isolated to that FRU. If fault
isolation was not performed, refer to
page 3-6.
This section describes procedures to remove and replace (RRP)
concurrent Sphereon 3032/3232 FRUs. A flat-blade screwdriver is
required to remove and replace the fan FRUs. No tools are required to
remove and replace the other FRUs. All FRUs are removed and
replaced while the switch is powered on and operational (concurrent
FRUs). Refer to Chapter
locations and part numbers.
Table 5-1 lists the FRUs and electrostatic discharge (ESD) precaution
requirements (yes or no) for each FRU.
FRU Name
FRU Removal and
MAP 0000: Start MAP
6, Illustrated Parts Breakdown
ESD Precaution Requirement
FRU Removal and Replacement
5
Replacement
on
for FRU
No
No
No
5-1