Table of Contents
Advertisement
Installing a Switch
Configure the Switch Module
3-6
McDATA 4416 Fibre Channel Switch Module Installation Guide
You can configure the switch using the McDATA Embedded Web Server
application, the McDATA Element Manager, or the command line interface.
Using McDATA Embedded Web Server or McDATA Element Manager, click
the Open Configuration Wizard radio button in the Initial Start dialog, then
click the Proceed button. The Configuration wizard explains and prompts
you for the following configuration information:
•
Archive template file
•
Switch domain ID
•
Domain ID Lock
•
Switch name
•
Permanent IP address
•
Permanent subnet mask
•
Permanent gateway address
•
Permanent network discovery method
•
Date and time
•
Admin account password
•
Create a configuration archive?
NOTE: Refer to the Reset command in the McDATA 4416 Command Line Interface
Guide for information about configuration default values.
To configure the switch using the command line interface, do the following:
1. Open a Telnet session with the default switch IP address and log in to the
switch with default account name and password (admin/password).
telnet 10.0.0.1
Switch Login: admin
Password:
*******
2. Open an admin session and enter the Set Setup System command. Enter
the values you want for switch IP address (Eth0NetworkAddress) and the
network mask (Eth0NetworkMask). Refer to the McDATA 4416 Command
Line Interface Guide for more information about this command.
DFCSM4Gb #> admin start
DFCSM4Gb (admin) #> set setup system
3. Open a Config Edit session and use the Set Config command to modify
the switch configuration. Refer to the McDATA 4416 Command Line
Interface Guide for more information about these commands.
Advertisement
Table of Contents
