Table of Contents
Advertisement
CONST_V6 Messages
Error Message %CONST_DIAG-6-HM_TEST_INFO: CPU util(5sec): SP=[dec]% RP=[dec]%
Traffic=[dec]% netint_thr_active[[dec]], Tx_Rate[[dec]], Rx_Rate[[dec]]
Error Message %CONST_DIAG-6-HM_TEST_SP_INFO: [chars][[dec]]:
last_busy_percent[[dec]%], Tx_Rate[[dec]], Rx_Rate[[dec]]
Error Message %CONST_DIAG-6-HM_TEST_RECOVERED: Module [dec] [chars] recovered after
[dec] consecutive failure(s)
CONST_V6 Messages
This section contains IP version 6 (CONST_V6) messages.
CONST_V6-5
Error Message %CONST_V6-5-FIB_EXCEP_OFF: Protocol IPv6 recovered from FIB exception
Error Message %CONST_V6-5-FIB_EXCEP_ON: Failed to insert an IPv6 prefix in hardware
FIB TCAM
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
2-64
Explanation
This message provides system resource information during an event.
This message is informational. No action is required.
Recommended Action
This message displays system resource information during the event
Explanation
This message is informational only. No action is required.
Recommended Action
The health-monitoring test recovered from transient failure on the specified module.
Explanation
Recommended Action
This message is informational. No action is required.
The IPv6 CEF table successfully reloaded to the hardware FIB TCAM. All IPv6 packets
Explanation
will be switched by the hardware.
Recommended Action
No action is required.
Explanation
The switch failed to insert an IPv6 entry into the hardware FIB TCAM because the total
number of software forwarding entries exceeded the hardware FIB TCAM limit. Some IPv6 packets
might be switched by the software.
Recommended Action
Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
Chapter 2
Messages and Recovery Procedures
OL-11469-02
Advertisement
Table of Contents
