Cisco III - Supervisor Engine III Message Manual page 62

C7600_SIP200_SPITX Messages
Error Message %C7600_SIP200_SPITX-3-CHANNEL_ENABLE_FAIL: SPI4 Channel [int] for Bay
[int], [chars] Failed
Explanation
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPITX-3-DESCR_ERR_SPA0: SPAstatus=[hex],
syndrome=[hex], RdRspOvf=[int], RdRspTo=[int], OvfVal=[int], OvfCh=[int],
OvfDescHi=[hex], OvfDescLo=[hex], DisChk=[int], SeqErrVal=[int], SeqErrCh=[int]
Explanation
while processing a TX descriptor. This condition could cause packets to drop.
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPITX-3-DESCR_ERR_SPA1: SPAstatus=[hex],
syndrome=[hex], RdRspOvf=[int], RdRspTo=[int], OvfVal=[int], OvfCh=[int],
OvfDescHi=[hex], OvfDescLo=[hex], DisChk=[int], SeqErrVal=[int], SeqErrCh=[int]
Explanation
while processing a TX descriptor. This condition could cause packets to drop.
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
2-32
The specified SPI4 channel could not be enabled or disabled.
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
The egress SPI4.2 device on the line card detected a sequence or FIFO overflow error
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
The egress SPI4.2 device on the line card detected a sequence or FIFO overflow error
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
Chapter 2 Messages and Recovery Procedures
under Product cat6000. If you still require
or contact your Cisco technical support
under Product cat6000. If you still require
or contact your Cisco technical support
under Product cat6000. If you still require
or contact your Cisco technical support
OL-11469-02