Table of Contents
Advertisement
Chapter 2
Messages and Recovery Procedures
Error Message %C7600_SIP200_SPITX-3-MISMATCH: Descriptor ring mismatch: expects
[int] got [int]
Explanation
what the line card CPU expected. This condition could cause packets to drop.
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPITX-3-OVERRUN_DROP: SPI4 overrun drops packet for SPA
[int], queue [int], count [int]
Explanation
controlled channel, it overruns the SPI4 channel but cannot queue it to the internal hold queue. This
indicates an internal software error.
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPITX-3-SPI4_ERR_SPA0: SPAstatus=[hex][chars]
Explanation
bus interface. This condition could cause packets to drop.
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPITX-3-SPI4_ERR_SPA1: SPAstatus=[hex][chars]
Explanation
bus interface. This condition could cause packets to drop.
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
OL-11469-02
The egress SPI4.2 device on the line card returned a descriptor entry that did not match
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
While the egress SPI4.2 device on the line card sends an packet on the extended flow
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
The egress SPI4.2 device on the line card detected an error condition with the SPI4.2
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
The egress SPI4.2 device on the line card detected an error condition with the SPI4.2
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
C7600_SIP200_SPITX Messages
under Product cat6000. If you still require
or contact your Cisco technical support
under Product cat6000. If you still require
or contact your Cisco technical support
under Product cat6000. If you still require
or contact your Cisco technical support
under Product cat6000. If you still require
or contact your Cisco technical support
2-39
Advertisement
Table of Contents
