Table of Contents
Advertisement
Chapter 2
Messages and Recovery Procedures
Error Message %SIP600_QOS-3-EXCEEDGUARTQRATE: SIP-600 Exceeded Guaranteed Rates on
interface - [chars]: [chars] [dec] Cause: [hex]
Explanation
specified action. This condition is the result of attempting to configure a QoS action. The sum of all
queue guaranteed rates has exceeded the maximum that can be configured for the interface to which
the queues are applied. This condition could be caused when the priority command is configured
without the police command.
Recommended Action
case, remove the service policy and reapply it. If the problem persists, copy the message exactly as
it appears on the console or in the system log. Research and attempt to resolve the issue using the
tools and utilities provided at http://www.cisco.com/tac. With some messages, these tools and
utilities will supply clarifying information. Search for resolved software issues using the Bug
Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case
with the Technical Assistance Center via the Internet at
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the information you have gathered. Attach the
following information to your case in nonzipped, plain-text (.txt) format: the output of the show
logging and show tech-support commands and your pertinent troubleshooting logs.
Error Message %SIP600_QOS-3-INSUFFDFLTBW: SIP-600 Insufficient bandwidth for default
processing: port [dec] queue id [dec] Cause: [hex]
Explanation
When a service policy is applied, this bandwidth is first deducted from the QoS class-default queue.
If there is not sufficient bandwidth in the class-default queue and the sum of queue guaranteed
bandwidth exceeds the link rate, this message is generated instead of the EXCEEDGUARTQRATE
message.
Recommended Action
made available for the port's queue to handle control packets. Reduce the amount of bandwidth
configured on user-defined classes so that more bandwidth is available for class-default. If
necessary, explicitly configure bandwidth for class-default by entering the bandwidth command. If
the problem persists, copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %SIP600_QOS-3-NORESOURCE: SIP-600 Out of Resources- [chars]: [chars]
[dec] Cause: [hex]
Explanation
Recommended Action
OL-11469-02
The SIP 600 received an error on the specified hardware queue when attempting the
Add the police command to limit the rate of the priority queue. If this is not the
The SIP 600 reserves 1 percent of the bandwidth of a port for router control packets.
Determine if there is any bandwidth available for class-default so that space is
The specified resource has been depleted from the SIP 600.
Change the SIP 600 configuration to conserve its use of the specified resource.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
SIP600_QOS Messages
2-235
Advertisement
Table of Contents
