Table of Contents
Advertisement
AP Messages
AP-1
Error Message %AP-1-POSTURE_POLICY_ERROR: POLICY=[chars]| POLICYNAME=[chars]|
IP=[IP_address]| ERROR=<[chars][chars]>
AP-4
Error Message %AP-4-AUTH_PROXY_NOMEM: Sufficient memory was not available to [chars]
Error Message %AP-4-POSTURE_EXCEED_MAX_INIT: Exceeded maximum limit ([dec]) on
entires in authentication proxy posture cache in initializing state
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
2-4
The specified policy was not applied for the given host IP due to the reason specified as
Explanation
Error.
When the "POLICY" character string is "HOST ACL," verify that an input
Recommended Action
access control list (ACL) is defined and configured on the interface. A "URL REDIRECT ACL"
policy needs a URL-redirect vendor-specific attribute (VSA) to have an associated access control
list URL-redirect-ACL VSA that can be used to determine HTTP redirect criteria. HTTP packets
that match the ACL are subject to redirection. When a URL-redirect-ACL access control list is not
specified or is not configured, the host will not be set up for HTTP redirection.
There was not enough memory to perform the specified operation.
Explanation
Reduce other system activity to ease memory demands. If conditions warrant,
Recommended Action
upgrade to a larger memory configuration.
The number of entries that are in the Authentication Proxy posture cache and in an
Explanation
initializing state has exceeded the maximum limit.
This condition might indicate a denial of service (DoS) attack. Copy the
Recommended Action
message exactly as it appears on the console or in the system log. Research and attempt to resolve
the issue using the tools and utilities provided at http://www.cisco.com/tac. With some messages,
these tools and utilities will supply clarifying information. Search for resolved software issues using
the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open
a case with the Technical Assistance Center via the Internet at
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the information you have gathered. Attach the
following information to your case in nonzipped, plain-text (.txt) format: the output of the show
logging and show tech-support commands and your pertinent troubleshooting logs.
Chapter 2
Messages and Recovery Procedures
OL-11469-02
Advertisement
Table of Contents
