Cisco III - Supervisor Engine III Message Manual page 132

DIAG Messages
Error Message %DIAG-3-INVALID_DEVICE: Invalid device number : [chars]
Explanation
Recommended Action
Error Message %DIAG-3-INVALID_MONITORING_INTERVAL: [chars]: The [chars][ID=[dec]]
monitoring interval must be at least [dec] millisec
Explanation
Recommended Action
Error Message %DIAG-3-INVALID_TEST: Invalid test: [chars]
Explanation
Recommended Action
available tests and their associated test IDs can be retrieved using the show diagnostic content
command.
Error Message %DIAG-3-MONITOR_DISABLE: [chars]: The monitoring test:[dec] is disable
since default interval is Zero
Explanation
Recommended Action
Error Message %DIAG-3-MONITOR_INTERVAL_ZERO: [chars]: Monitoring interval is 0.
Cannot enable monitoring for Test #[dec]
Explanation
is set to zero.
Recommended Action
monitoring.
Error Message %DIAG-3-NOT_MONITORING_TEST: [chars]: The test:[dec] cannot be used as
health monitoring test
Explanation
Recommended Action
Error Message %DIAG-3-TEST_SKIPPED: [chars]: [chars]{ID=[dec]} is skipped
Explanation
Recommended Action
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
2-102
The system made a diagnostics request on a device that does not exist.
Ensure that the specified device number exists and is valid.
The specified test monitoring interval is too small.
No action is required. The system is working properly.
A test that does not exist was requested. [chars] describes the test.
Ensure the specified test is supported by the switching module. The list of
The specified test is no longer a health monitoring test.
No action is required. The system is working properly.
The system cannot enable health monitoring for the specified test because the interval
Reset the health monitoring interval for the test, and reenable health
The specified test is not a health monitoring test.
No action is required. The system is working properly.
The diagnostic test cannot be run.
No action is required. The system is working properly.
Chapter 2 Messages and Recovery Procedures
OL-11469-02