Table of Contents
Advertisement
Chapter 2
Messages and Recovery Procedures
Error Message %MLSCEF-2-FIB_SSRAM_WRITE_INCONSISTENCY: FIB SSRAM Mismatch for Index:
[dec] Expected: [hex], Hardware: [hex]
Explanation
Recommended Action
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %MLSCEF-2-FIB_TCAM_WRITE_INCONSISTENCY: FIB TCAM Mismatch for [chars]:
Index: [dec]
Expected: Entry: [hex]-[hex]-[hex]
Hardware: Entry: [hex]-[hex]-[hex]
Explanation
The specific entry could be bad.
Recommended Action
show ver commands. Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %MLSCEF-2-RELOAD: maximum routes config mismatch. Reloading with
correct config
Explanation
current route allocation. A system reload is required to correct this condition.
Recommended Action
maximum-routes command has not been entered, copy the error message exactly as it appears on
the console or in the system log. Enter the show tech-support command. Contact your Cisco
technical support representative, and provide the representative with the gathered information. If the
message does not appear continuously and the mls cef maximum-routes command has been
entered, no action is required.
OL-11469-02
A problem occurred when the system attempted to write the FIB SSRAM.
Copy the message exactly as it appears on the console or in the system log.
A problem occurred when the system attempted to write the specified FIB TCAM entry.
Collect the output of the show mls cef hardware and show mls cef log and
The system detected a mismatch between the user configuration route allocation and the
If this message appears continuously on the same module and the mls cef
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
MLSCEF Messages
2-171
Advertisement
Table of Contents
