Table of Contents
Advertisement
C6KENV Messages
Error Message %C6KENV-2-BADFLOWCTRL_WARN: WARNING: Module [dec] not at an
appropriate hardware revision level to support DFC3
Explanation
revision level to support a DFC3 or higher.
Recommended Action
appropriate hardware revision level.
Error Message %C6KENV-2-BADPINN1: Module [dec] not at an appropriate hardware
revision level to coexist with PFC3 system. Power denied
Explanation
this revision will experience problems when they are used with a supervisor engine with a PFC3
installed and they should not be used.
Recommended Action
Error Message %C6KENV-2-BADTRANSCEIVER: Module [dec] will be power disabled because
an inappropriate transceiver is inserted at [chars].
Explanation
This transceiver should not be used in this system.
Recommended Action
transceiver was purchased from Cisco, contact your Cisco technical support representative to get the
transceiver replaced.
Error Message %C6KENV-2-C2PLUSWITHNODB: The constellation 2 plus module in slot
[dec] has no forwarding daughter board. Power denied
Explanation
have either a distributed, accelerated, or centralized forwarding card. This module will not be
activated and will remain powered down.
Recommended Action
Error Message %C6KENV-2-DFCMISMATCH: Module [dec] DFC incompatible with Supervisor
DFC. Power denied
Explanation
The module will not be activated and remains powered down.
Recommended Action
the module and the DFC in the supervisor engine.
Error Message %C6KENV-2-DFCMISMATCHMINOR: Module [dec] DFC installed is incompatible
with system operating mode. Power denied. To enable Module [dec] DFC, the system
must be reset.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
2-20
The fabric-capable module in the specified slot is not at an appropriate hardware
When you upgrade the DFC daughter card, also upgrade the module to an
The module specified in the error message has a revision of 2.x or below. Modules with
Upgrade the module to an appropriate hardware revision level.
An incompatible transceiver is inserted at the interface specified in the error message.
Remove the specified transceiver and restore power to the module. If this
The module in the slot specified has no forwarding daughter card and is expected to
Enter the show module command to view error message details.
The DFC in the specified module is different from the DFC in the supervisor engine.
Enter the show module command to view the difference between the DFC in
Chapter 2
Messages and Recovery Procedures
OL-11469-02
Advertisement
Table of Contents
