Cisco III - Supervisor Engine III Message Manual page 60

C7600_SIP200_SPIRX Messages
Error Message %C7600_SIP200_SPIRX-3-SPA_INTERRUPT: SPA [int] - [chars], SPA Int
status = [hex]
Explanation
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPIRX-3-SPI4_LINKERROR: SPA Bay [int], [int] SPI4 Link
Failures
Explanation
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPIRX-3-SRAM_ERROR_DATA: SRAM[dec] Address = [hex][hex]
Data = [hex][hex][hex]_[hex][hex][hex]_[hex][hex][hex]_[hex][hex] [hex]
Explanation
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPIRX-3-SRAM_INTERRUPT: [chars], Sram Int status = [hex]
Explanation
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
2-30
A SPA interrupt from the ingress SPI4.2 device has occurred.
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
Link errors from the ingress SPI4.2 device have occurred.
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
An SRAM address and data dump has occurred.
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
An SRAM interrupt has occurred from the ingress SPI4.2 device.
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
Chapter 2 Messages and Recovery Procedures
under Product cat6000. If you still require
or contact your Cisco technical support
under Product cat6000. If you still require
or contact your Cisco technical support
under Product cat6000. If you still require
or contact your Cisco technical support
under Product cat6000. If you still require
or contact your Cisco technical support
OL-11469-02