Table of Contents
Advertisement
Chapter 2
Messages and Recovery Procedures
SSP Messages
This section contains State Synchronization Protocol Manager (SSP) messages.
SSP-3
Error Message %SSP-3-DATACREATEFAIL: Creation of required data structures failed.
Error Message %SSP-3-EXCEEDMAXDOI: SSP maximum DOI exceeded.
Error Message %SSP-3-NOSTART: SSP could not initialize.
Error Message %SSP-3-SRVSOCKCREATEFAIL: SSP socket creation failed.
OL-11469-02
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
The SSP will not operate properly due to the abnormal initialization of required data
Explanation
structures.
Reload the device. If the error persists, contact your technical service
Recommended Action
representative.
The configuration has exceeded the maximum number of SSP clients allowed on this
Explanation
device at any one time.
Verify your configuration and reduce the number of SSP clients running at the
Recommended Action
same time. If a large number of SSP clients is required, contact your technical service representative
for assistance.
The SSP process could not successfully initialize. This condition might be caused by
Explanation
unusual protocol startup times in certain topologies.
Recommended Action
Ensure that your IP redundancy mechanism (HSRP) configuration is valid and
that all protocols have started. Try to configure SSP again. If this error recurs, contact your technical
support representative.
The SSP process could not establish a socket connection with the SSP peer. This
Explanation
condition is likely to occur because either the device is under extreme load or it is misconfigured.
Verify that the SSP configuration is valid. Configure SSP to use a different port
Recommended Action
number. Reduce the load on the device.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
SSP Messages
2-247
Advertisement
Table of Contents
