Cisco III - Supervisor Engine III Message Manual page 67

Chapter 2 Messages and Recovery Procedures
Error Message %C7600_SIP200_SPITX-3-FCSTAT_FAIL_SPA2: [chars]
Explanation
synchronization failure. This condition could cause packets to drop.
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPITX-3-FCSTAT_FAIL_SPA3: [chars]
Explanation
synchronization failure. This condition could cause packets to drop.
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPITX-3-INITFAIL: Failed to configure the egress SPI4.2
device. Error = [hex]
Explanation
indicates an internal hardware error.
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPITX-3-INT_PERR_SPA0: IntMemPerr=[hex][chars]
Explanation
condition could cause packets to drop.
Recommended Action
Toolkit at
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create
OL-11469-02
The egress SPI4.2 device on the line card detected a SPI4.2 status clock or
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
The egress SPI4.2 device on the line card detected a SPI4.2 status clock or
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
The egress SPI4.2 device on the line card could not be programmed or configured. This
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
The egress SPI4.2 device on the line card detected an internal memory parity error. This
If this problem recurs, search for resolved software issues using the Bug
http://tools.cisco.com/Support/BugToolKit/
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
C7600_SIP200_SPITX Messages
under Product cat6000. If you still require
or contact your Cisco technical support
under Product cat6000. If you still require
or contact your Cisco technical support
under Product cat6000. If you still require
or contact your Cisco technical support
under Product cat6000. If you still require
or contact your Cisco technical support
2-37