Hot-Plug Power Supply - Compaq ProLiant 6400R Maintenance And Service Manual

Hot-Plug Power Supply

NOTE: It is not necessary to place the system in Standby for a hot-plug power supply replacement in a
redundant power supply configuration.
To remove a hot-plug power supply,
1. Unplug the AC power cord from the hot-plug power supply.
2. Grasp the power supply handle, and slide the release lever upward
3. Pull the power supply from the server
Figure 2-22. Removing a hot-plug power supply
Reverse steps 1 through 3 to replace a hot-plug power supply.
WARNING: To reduce the risk of electric shock or damage to the equipment,
I Unplug the power cord before removing the power supply from the server.
I Install the power supply before connecting the power cord to the power supply.
CAUTION: If one of the power supplies is removed, it must either be replaced by another
power supply, or a blank bezel should be inserted immediately to allow proper airflow. Do not
operate for more than a few minutes without taking these precautions.
B
2
Removal and Replacement Procedures 2-25
.

A
.


1