Compaq ProLiant 6400R Maintenance And Service Manual page 85

3-18 Compaq ProLiant 6400R Maintenance and Service Guide
Table 3-2
POST Error Messages
Error Code
1786-Drive Array
Recovery Needed
The following drive(s)
need Automatic Data
Recovery: Drive X.
Select "F1" to
continue with
recovery of data to
drive(s).
Select "F2" to
continue without
recovery of data to
drive(s).
1787-Drive Array
Operating in Interim
Recovery Mode.
Physical drive
replacement needed:
Drive X
1788-Incorrect Drive
Replaced: Drive X
Drive(s) were
incorrectly replaced:
Drive Y Select "F1"
to continue - drive
array will remain
disabled. Select "F2"
to reset configuration
- all data will be lost.
1789-Drive Not
Responding, Physical
Drive
Check cables or
replace physical
drive X.
Select "F1" to
continue - drive array
will remain disabled.
Select "F2" to fail
drive(s) that are not
responding -
Interim Recovery
Mode will be enabled
if configured for fault
tolerance.
continued
Audible Beeps Probable Source of Problem
None Interim Data Recovery mode.
Data have not been recovered
yet.
None Hard drive X failed, or a cable is
loose or defective. After a system
restart, this message reminds
you that drive X is defective and
fault tolerance is being used.
None Because the drives are not
installed in their original
positions, they have been
disabled. See note below.
None Cable or hard drive failure
Recommended Action
Press F1 to allow automatic
data recovery to begin. Data will
automatically be restored to
drive X now that the drive has
been replaced or seems to
working.
-or-
Press F2. The system will
continue to operate in the
Interim Data Recovery mode.
1. Replace drive X as soon as
possible.
2. Check loose cables.
3. Replace defective cables.
Reinstall the drives correctly as
indicated.
Press F1 to restart the computer
with the drive array disabled.
-or-
Press F2 to use the drives as
configured and lose all the data
on them.
1. Check the cable
connections.
2. Replace the cables.
3. Replace the drive. If you
do not want to replace the
drive now, press F2.
continued