Compaq ProLiant 6400R Maintenance And Service Manual page 121

3-54 Compaq ProLiant 6400R Maintenance and Service Guide
Table 3-21
Compaq System Configuration Utility Pager Settings for Booting into Compaq Utilities
Pager Data
Pager message
Pager test
Serial interface
Dial-in status
Dial-out status
Dial-out string
Network status
Setting Description
1234567# Represents a unique number (maximum of seven numeric only digits)
that you must designate to identify the server on the pager display. The
ROM adds a three-digit code to the front of the number. The first two
indicate the subsystem, and the third indicates the severity of the error
that caused the alert. The # symbol usually terminates the message. If
no message is required, delete the # symbol.
Select to test
Test the current pager settings. Press Enter to dial the pager number,
pager setup and the pager message (if present) displays. You must configure the
computer before testing the pager, and the Pager Status must be set to
Enabled. Do not test the pager if you run remotely and use only one
modem.
COM1 Select the communications port for the modem used by the pager and
the remote ASR-2 functions. The options are COM1 and COM2.
Enabled Set Dial-In Status to Enabled. Be sure the Reset Boot option is set to
Boot Compaq Utilities. When the system starts because of an ASR reset,
it starts to the Compaq Utilities, sets the Management Modem to
auto-answer, and waits for the administrator to dial in and run the
Compaq Utilities.
You automatically disable the option when you configure the software
error recovery start option to Boot Operating System. When ASR pages
you, you cannot dial in unless ASR-2 exceeds 10, the threshold number
of server restart retries. When this happens, ASR-2 restarts the server
into the Compaq Utilities and places the modem in auto-answer mode.
Enabled Enables ASR-2 to dial a remote workstation. If you selected this option,
Dial-In Status is automatically selected.
To use the dial-out feature, set Dial-Out Status to Enabled, and set the
Dial-Out String to the correct phone number. You must also set the
Reset Boot option to Boot Compaq Utilities. When the system restarts
because of an ASR reset, the administrator is paged by the Pager Status
and Pager Dial String. The system restarts to the Compaq Utilities and
dials the telephone number provided in the Dial-Out string. The number
will be tried five times. If it fails to connect after five attempts, the
modem is put in autoanswer mode.
555-1234 Enter the dial string followed by the remote computer telephone number.
To use IPX network access, set Network Protocol to IPX. When the
system restarts to the Compaq Utilities because of an ASR reset, it loads
IPX network support. This enables remote access using NVT.
To use IP network access, set Network protocol to IP. Also make sure to
set Network IP address, Network IP net mask, and Network IP router
address. When the system restarts to the Compaq Utilities because of an
ASR reset, it loads IP network support. This enables remote access
using Telnet.
Note: The Network Status must be set to Enabled for network access.
continued
continued