Compaq ProLiant 6400R Maintenance And Service Manual page 75

3-8 Compaq ProLiant 6400R Maintenance and Service Guide
Table 3-2
POST Error Messages
Error Code
164-Memory Size
Error
172-Configuration
Nonvolatile Memory
Invalid
173-Slot ID
Mismatch
174-Configuration/
Slot Mismatch Device
Not Found
175-Configuration/
Slot Mismatch Device
Found
177-Configuration
Not Complete
178-Processor
Configuration Invalid
180-Log Reinitialized
201-Memory Error
203-Memory
Address Error
207-Invalid Memory
Configuration -
Check DIMM [SIMM]
Installation
208-Invalid Memory
Speed – Check DIMM
[SIMM] Installation
209-Memory
Detection Failure.
Check Memory
Installation
211-Cache Switch
Set Incorrectly
continued
Audible Beeps Probable Source of Problem
2 short Incorrect configuration memory.
None Corrupt nonvolatile configuration
or jumper installed
None Board replaced, configuration not
updated.
None EISA or PCI board not found
None EISA or PCI board added,
configuration not updated.
None Incomplete system configuration
None Processor type or step does not
match configuration memory.
None
None RAM failure
None RAM failure
None Memory module installed
incorrectly.
1 long, 1 short The speed of the memory is too
slow:
I xx00 = expansion board
I 00yy = system board SIMMs
I xx and yy have a
1 long, 1 short Unable to size memory
None Switch not set properly during
installation or upgrade.
SIMMs are too slow.
are too slow.
corresponding bit set.
Recommended Action
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run Diagnostics. Replace the
failed assembly as indicated.
Run Diagnostics. Replace the
failed assembly as indicated.
Verify the placement of memory
modules.
The speed of the memory
modules must be 60 ns. Verify
the speed of the memory
modules installed, and replace
them if slower than 60 ns.
Check DIMM installation. If error
persists, call Compaq service
provider.
Verify switch settings.
continued