Compaq ProLiant 6400R Maintenance And Service Manual page 108

Table 3-18
ADU Diagnostic Messages
Message Description
SCSI Port x Drive ADU found drive that needs to be
ID x failed – replaced.
REPLACE (failure
message)
SCSI Port x Drive Drive firmware is below
ID x firmware recommended version.
needs upgrading
SCSI Port x Drive Drive has loose cable.
ID x has a loose
cable. SMART is
unable to
communicate
with drive
SCSI Port x Drive ADU found drive was replaced even
ID x was though volume was fine.
replaced on a
good volume:
(failure message)
SCSI port X, Drive firmware may cause problems
drive ID Y and should be upgraded.
firmware needs
upgrading
Set configuration The configuration of the array
command issued controller has been updated. The
array accelerator board may remain
disabled until it is reinitialized.
Soft Firmware ADU has determined that the
Upgrade controller is running firmware that
required has been soft upgraded by the
Compaq Upgrade Utility. However,
the firmware running is not present
on all drives. This could be caused by
the addition of new drives in the
system.
Unable to Controller could not communicate
communicate with drive.
with drive on
SCSI Port x,
Drive ID x
Unknown disable A code was returned from the array
code accelerator board that ADU does not
recognize.
continued
Diagnostics and Troubleshooting 3-41
Recommended Action
Replace drive or correct condition that caused
error.
Run Options ROMPaq to upgrade drive to latest
firmware revision.
Turn off the system. Check drive cable for tight
connection.
No action needed.
Run Options ROMPaq to upgrade the firmware
on the drive to a later version.
Run the System Configuration Utility to
reinitialize the array accelerator board.
Run the Compaq Upgrade Utility to place the
latest firmware on all drives.
If the amber LED on the drive is on, replace the
drive.
Obtain the latest version of ADU.
continued