Compaq ProLiant 6400R Maintenance And Service Manual page 80

Table 3-2
POST Error Messages
continued
Error Code
1731-Fixed Disk 1
does not support
DMA Mode.
1740-Fixed Disk 0
failed Set Block
Mode command
1741-Fixed Disk 1
failed Set Block
Mode command
1750-Fixed Disk 0
failed Identify
command
1751-Fixed Disk 1
failed Identify
command
1760-Fixed Disk 0
does not support
Block Mode
1761-Fixed Disk 1
does not support
Block Mode
1764-Slot x Drive Array - Capacity Expansion Process is temporarily disabled,
followed by one of the following.
I Expansion will resume when Array Accelerator has been reattached.
I Expansion will resume when Array Accelerator has been replaced.
I Expansion will resume when Array Accelerator RAM allocation is successful.
I Expansion will resume when Array Accelerator battery reaches full charge.
I Expansion will resume when automatic data recovery has been completed.
1765-Slot x Drive Array Option ROM Appears to Conflict With an ISA Card. ISA
cards with 16-bit memory cannot be configured in memory range C0000 to DFFFF
along with the SMART-2/E 8-bit Option ROM due to EISA bus limitations. Please
remove or reconfigure the ISA card.
1766-Slot x Drive Array requires System ROM Upgrade. Run Systems ROMPaq
Utility.
Audible Beeps Probable Source of Problem
None Hard drive error
None Hard drive error
None Hard drive error
None Hard drive error
None Hard drive error
None Hard drive error
None Hard drive error
Diagnostics and Troubleshooting 3-13
Recommended Action
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Reattach or replace array
accelerator. Wait until the array
accelerator batteries have
charged or for automatic data
recovery to complete, as
indicated.
Remove or reconfigure
conflicting ISA cards. Disable
the shared memory on any ISA
network cards that may be
installed.
Run the latest Systems ROMPaq
Utility to upgrade the System
ROMs.
continued