Compaq ProLiant 6400R Maintenance And Service Manual page 102

Table 3-18
ADU Diagnostic Messages
Message Description
Board not Array controller configured for use
attached with array accelerator board, but one
is not attached.
Configuration ADU detected that nonvolatile RAM
signature is zero contains a configuration signature of
zero. Old versions of the System
Configuration Utility could cause this.
Configuration Array accelerator board configured
signature for a different array controller board.
mismatch Configuration signature on array
accelerator board does not match the
one stored on the array controller
board.
Controller Controller communication failure
communication occurred.
failure occurred
Controller EISA nonvolatile RAM does not
detected. contain a configuration for this
NVRAM controller.
configuration not
present
Controller Controller firmware is below the
firmware needs latest recommended version.
upgrading
Controller is Controller is installed in slot for
located in special video control signals. If
special "video" controller is used in this slot, LED
slot indicators on front panel may not
function properly.
Controller is not Controller is not configured. If
configured controller was previously configured
and you change drive locations, there
may be a problem with placement of
the drives. ADU examines each
physical drive and detects drives that
have been moved to a different drive
bay.
Controller The controller returned an error from
reported POST its internal POSTs.
error.
Error Code: x
continued
Diagnostics and Troubleshooting 3-35
Recommended Action
Attach array accelerator board to array
controller.
Run the latest version of System Configuration
Utility to configure the controller and nonvolatile
RAM.
To recognize the array accelerator board, run
the ACU.
ADU was unable to successfully issue
commands to the controller in this slot.
Run the System Configuration Utility to
configure the nonvolatile RAM.
Run Options ROMPaq to upgrade the controller
to the latest firmware revision.
Install the controller In a different slot and run
the System Configuration Utility to configure the
controller and nonvolatile RAM. Then run the
ACU to the configure controller.
Look for messages indicating which drives have
been moved. If none appear and drive swapping
did not occur, run the ACU to configure the
controller and run the System Configuration
Utility to configure nonvolatile RAM. Do not run
either utility if you believe drive swapping has
occurred.
Replace the controller.
continued