Compaq ProLiant 6400R Maintenance And Service Manual page 122

Table 3-21
Compaq System Configuration Utility Pager Settings for Booting into Compaq Utilities
Pager Data Setting
Network Compaq
controller
Network host CPQHOU
name
Network card Slot #
slot
Network frame ETHERNET_I I
type
Network IP
address
Network IP net
mask
Network IP
router address
If you configure the server to boot into Compaq Utilities, it prepares for remote
communications. You can remotely run Diagnostics software, the Inspect Utility, or the System
Configuration Utility using a workstation running terminal emulation software, such as Compaq
Insight Manager or PC Anywhere.
Description
For all Compaq standard network controllers.
Enter the network name of the server. Use underscores instead of
spaces within the name—for example, Compaq Server. If you use IPX
network access to the Compaq Utilities, the server name is used to
advertise NVT host services. The name displays in the Compaq Insight
Manager server list when the program determines that it can
communicate with NVT. Set the name to be the same as the server
name you assign when the host OS is running.
Select the slot number of the network interface card for network access
to Compaq Utilities.
Select the frame type for the network. Selections include both the
Ethernet and Token Ring.
Enter the IP address for this server in standard dot notation.
Note: This is not used if you select Custom for Network controller. You
must enter the IP address in the NET.CFG file that you load into the
system partition.
Enter the net mask for the server in standard dot notation.
Note: This is not used if you select Custom for network controller. You
must enter the IP address in the NET.CFG file that you load into the
system partition.
Enter the router to be used for the server in standard dot notation.
Note: This is not used if you select Custom for network controller. You
must enter the IP address in the NET.CFG file that you load into the
system partition.
Diagnostics and Troubleshooting 3-55
continued