Compaq ProLiant 6400R Maintenance And Service Manual page 36

24X or Higher Low-Profile CD-ROM Drive Adapter Board
The 24X or higher low-profile CD-ROM drive adapter board may be removed with the
removable media assembly still secured to the server or by removal of the removable media
assembly. See "Removable Media Assembly" earlier in this chapter.
To remove the 24X or higher low-profile CD-ROM drive adapter board,
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the removable media assembly. See "Removable Media Assembly" earlier in this
chapter.
3. Disconnect the IDE and power cables from the adapter board
done so.
4. Remove the two thumbscrews
assembly.
5. Unplug the CD-ROM drive adapter board from the back of the 24X or higher low-profile
CD-ROM drive
2
1
Figure 2-14. Removing the 24X or higher low-profile CD-ROM drive adapter board
NOTE: The CD-ROM drive has been removed from the removable media assembly for clarity.
Reverse steps 1 through 5 to replace the 24X or higher low-profile CD-ROM drive adapter
board.
securing the adapter board to the removable media

.

Removal and Replacement Procedures 2-19
if you have not already


3