Compaq ProLiant 6400R Maintenance And Service Manual page 77

3-10 Compaq ProLiant 6400R Maintenance and Service Guide
Table 3-2
POST Error Messages
Error Code
ZZ-301-Keyboard
Error
303-Keyboard
Controller Error
304-Keyboard or
System Unit Error
40X-Parallel Port X
Address Assignment
Conflict
601-Diskette
Controller Error
605-Diskette Drive
Type Error
1151-Com Port 1
Address Assignment
Conflict
1152-Com Port 2, 3,
or 4 Address
Assignment Conflict
1610-Temperature
violation detected.
Waiting for system to
cool
1611-Fan failure
detected
1611-I/O Fan (Fan X)
failure detected
continued
Audible Beeps Probable Source of Problem
None Keyboard failure. (ZZ represents
the Keyboard Scan Code.)
None System board, keyboard, or
mouse controller failure
None Keyboard, keyboard cable, or
system board failure
2 short Both external and internal ports
are assigned to parallel port X.
None Diskette controller circuitry
failure
2 short Mismatch in drive type
2 short Both external and internal serial
ports are assigned to COM1.
2 short Both external and internal serial
ports are assigned to COM2,
COM3, or COM4.
2 short Ambient system temperature is
too hot.
2 short Required fan not installed or
spinning
2 short I/O fan 1, 2, 3, or 4 has failed.
Recommended Action
1. Free the stuck key.
2. Replace the keyboard.
1. Run Diagnostics.
2. Replace failed assembly
as indicated.
1. Make sure the keyboard is
attached.
2. Run Diagnostics to
determine which is in
error.
3. Replace the part indicated.
Run the System Configuration
Utility and correct.
1. Make sure the diskette
drive cables are attached.
2. Replace the diskette drive
and/or cable.
3. Replace the system board.
Run the System Configuration
Utility to set the diskette type
correctly.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Check fan in system
environment.
Check fans.
Replace the failed fan.
continued