Installing Content From Solution Packs - Novell SENTINEL RAPID DEPLOYMENT 6.1 - 12-2009 User Manual

14.3.3 Installing Content from Solution Packs

To use the content of a Solution Pack in the Sentinel Control Center, you must install the Solution
Pack or selected controls in a Sentinel system (also known as the "target" Sentinel system).
"Installing the Contents of a Solution Pack" on page 321
"Correlation Rules and Actions" on page 322
"JasperReports" on page 323
"Default Reports" on page 323
"Content Placeholders" on page 324
"Duplicate Content within a Solution Pack" on page 324
"Content with the Same Name in the Target Sentinel System" on page 325
When you install either a Solution Pack or an individual control, all of the child nodes are installed.
Installing the Contents of a Solution Pack
1 Go to Tools > Solution Packs.
2 Double-click a Solution Pack to open Solution Manager. Alternatively, you can click the Open
with Solution Manager icon. The Solution Manager window displays.
3 Select a Solution Pack or a control you want to install, then click Install.
Alternatively, right-click a Solution Pack or control and select Install. The Install Control
Wizard displays. If you select a Solution Pack, all the controls in that Solution Pack display. If
you select an individual control, that control is displayed in the Install Control Wizard window.
4 Click Next. If correlation rules or reports are included in the Solution Pack, you need to proceed
through several additional screens until you reach the Install Content window.
Solution Packs 321