Table of Contents
Advertisement
Report Parameters
MinSev
MaxSev
Email Report To
5 Click Run.
A report results entry is created and mailed to the designated recipients.
1.3.2 Viewing Reports
You can view the reports for different applications in the Sentinel Rapid Deployment Web interface
for reports. The report GUI by default shows up to 10 report results for any given report definition.
The 10 report results displayed are the 10 most recent report results for that report definition.
If there are more than 10 report results for any given report definition (that is, the report has been run
more than 10 times), a Show all x reports link is displayed after the 10th report, where x is the total
number of results available for that given report definition.
1 To view the list of report results, click View.
All previously run reports are shown with the user-defined report name, the user who ran them,
and the time the report was run.
IMPORTANT: The default number of report results to be displayed for each report definition
is managed by the
das_core.xml
<obj-component id="JasperReportingComponent">
<class>esecurity.ccs.comp.reporting.jasper.JasperReportingComponent</
class>
<property name="reporting.reportResultsDisplayed">10</property>
</obj-component>
You can change the
this value, ensure that you restart the das_core to apply the changes.
24
Sentinel 6.1 Rapid Deployment User Guide
Description
Specify the minimum severity of events to be included in the
report. The range is 0-5.
Specify the maximum severity of events to be included in the
report. The range is 0-5.
If the report should be mailed to a user or users, specify their e-
mail addresses, separated by commas.
To enable mailing reports, the administrator must configure the
mail relay under Rules > Configuration.
reporting.reportResultsDisplayed
file.
reporting.reportResultsDisplayed
property specified in the
property value. After changing
Advertisement
Table of Contents
