Table of Contents
Advertisement
4 Open the User Manager window.
5 Click the Permissions tab.
6 Select Solution Designer, Solution Manager, or Solution Pack, which automatically selects
both child permissions. The new permissions are applied the next time the user logs in.
14.2 Solution Manager
After a Solution Pack is imported, the Solution Manager in the Sentinel Control Center is used to
install, implement and test each control.
Installing a control installs the child content for the control into the Sentinel system. When the
content is initially installed, its status is Not Implemented.
Implementing a control is the process to configure event source systems and Sentinel to use the
content associated with the control. Novell Solution Packs include detailed documentation
describing implementation steps. The user should change the status of the control to
Implemented after following all of these steps.
Testing a control is the process to verify the content associated with the control. Novell
Solution Packs include detailed documentation describing testing steps. The user should
change the status of the control to Tested after following all of these steps.
To use the Solution Manager, a user must be assigned Solution Manager permissions under Solution
Pack. For more information, see
page
313.
314 Sentinel 6.1 Rapid Deployment User Guide
Section 14.1.2, "Permissions for Using Solution Packs," on
Advertisement
Table of Contents
