Selecting Ip Dscp Priority; Mapping Dscp Priority; Figure 3-74. Ip Dscp Priority Status - SMC Networks 8748L2 Management Manual

C
ONFIGURING THE
• The precedence for priority mapping is IP DSCP Priority, and then
Default Port Priority.

Selecting IP DSCP Priority

The switch allows you to enable or disable IP DSCP priority.
Command Attributes
• Enabled – Enables the priority services. (Default Setting: Disabled)
• IP DSCP – Maps layer 3/4 priorities using Differentiated Services
Code Point Mapping.
Web – Click Priority, IP DSCP Priority Status. Check Enabled, then click
Apply.

Mapping DSCP Priority

The DSCP is six bits wide, allowing coding for up to 64 different
forwarding behaviors. The DSCP retains backward compatibility with the
three precedence bits so that non-DSCP compliant will not conflict with
the DSCP mapping. Based on network policies, different kinds of traffic
can be marked for different kinds of forwarding. The DSCP default values
are defined in the following table. Note that all the DSCP values that are
not specified are mapped to CoS value 0.
3-160
S
WITCH

Figure 3-74. IP DSCP Priority Status