The Ipsec Monitor Screen - ZyXEL Communications ZYWALL USG 20 Manual

Chapter 9 Monitor
The following table describes the labels in this screen.
Table 37 Monitor > System Status > USB Storage
LABEL
Device
description
Usage
Filesystem
Speed
Status
Detail

9.12 The IPSec Monitor Screen

You can use the IPSec Monitor screen to display and to manage active IPSec
SAs. To access this screen, click Monitor > VPN Monitor > IPSec. The following
196
DESCRIPTION
This is a basic description of the type of USB device.
This field displays how much of the USB storage device's capacity is
currently being used out of its total capacity and what percentage that
makes.
This field displays what file system the USB storage device is formatted
with. This field displays Unknown if the file system of the USB storage
device is not supported by the ZyWALL, such as NTFS.
This field displays the connection speed the USB storage device
supports.
Ready - you can have the ZyWALL use the USB storage device.
Click Remove Now to stop the ZyWALL from using the USB storage
device so you can remove it.
Unused - the connected USB storage device was manually unmounted
by using the Remove Now button or for some reason the ZyWALL
cannot mount it.
Click Use It to have the ZyWALL mount a connected USB storage
device. This button is grayed out if the file system is not supported
(unknown) by the ZyWALL.
none - no USB storage device is connected.
This field displays any other information the ZyWALL retrieves from the
USB storage device.
Deactivated - the use of a USB storage device is disabled (turned off)
on the ZyWALL.
OutofSpace - the available disk space is less than the disk space full
threshold (see Section 43.2 on page 630
threshold).
Mounting - the ZyWALL is mounting the USB storage device.
Removing - the ZyWALL is unmounting the USB storage device.
none - the USB device is operating normally or not connected.
for how to configure this
ZyWALL USG 20/20W User's Guide