Vlan Summary Screen - ZyXEL Communications ZYWALL USG 20 Manual

Chapter 11 Interfaces

11.8.1 VLAN Summary Screen

This screen lists every VLAN interface and virtual interface created on top of VLAN
interfaces. To access this screen, click Configuration > Network > Interface >
VLAN.
Figure 176 Configuration > Network > Interface > VLAN
Each field is explained in the following table.
Table 65 Configuration > Network > Interface > VLAN
LABEL
Edit
Remove
Activate
Inactivate
Create
Virtual
Interface
Object
References
#
Status
Name
Port/VID
IP Address
Mask
266
DESCRIPTION
Double-click an entry or select it and click Edit to open a screen where you
can modify the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms you
want to remove it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To open the screen where you can create a virtual interface, select an
interface and click Create Virtual Interface.
Select an entry and click Object References to open a screen that shows
which settings use the entry. See
example.
This field is a sequential value, and it is not associated with any interface.
This icon is lit when the entry is active and dimmed when the entry is
inactive.
This field displays the name of the interface.
For VLAN interfaces, this field displays
• the Ethernet interface on which the VLAN interface is created
• the VLAN ID
For virtual interfaces, this field is blank.
This field displays the current IP address of the interface. If the IP address is
0.0.0.0, the interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address
(STATIC) or dynamically assigned (DHCP). IP addresses are always static
in virtual interfaces.
This field displays the interface's subnet mask in dot decimal notation.
Section 11.3.2 on page 232
ZyWALL USG 20/20W User's Guide
for an