ZyXEL Communications ZYWALL USG 20 Manual page 691

The following table describes the fields in this screen.
Table 214 Configuration > Log & Report > Log Setting > Active Log Summary
LABEL
System log
E-mail Server
1
E-mail Server
2
Remote Server
1~4
#
Log Category
ZyWALL USG 20/20W User's Guide
DESCRIPTION
Use the System Log drop-down list to change the log settings for all of
the log categories.
disable all logs (red X) - do not log any information for any category
for the system log or e-mail any logs to e-mail server 1 or 2.
enable normal logs (green check mark) - create log messages and
alerts for all categories for the system log. If e-mail server 1 or 2 also
has normal logs enabled, the ZyWALL will e-mail logs to them.
enable normal logs and debug logs (yellow check mark) - create log
messages, alerts, and debugging information for all categories. The
ZyWALL does not e-mail debugging information, even if this setting is
selected.
Use the E-Mail Server 1 drop-down list to change the settings for e-
mailing logs to e-mail server 1 for all log categories.
Using the System Log drop-down list to disable all logs overrides your
e-mail server 1 settings.
enable normal logs (green check mark) - e-mail log messages for all
categories to e-mail server 1.
enable alert logs (red exclamation point) - e-mail alerts for all
categories to e-mail server 1.
Use the E-Mail Server 2 drop-down list to change the settings for e-
mailing logs to e-mail server 2 for all log categories.
Using the System Log drop-down list to disable all logs overrides your
e-mail server 2 settings.
enable normal logs (green check mark) - e-mail log messages for all
categories to e-mail server 2.
enable alert logs (red exclamation point) - e-mail alerts for all
categories to e-mail server 2.
For each remote server, use the Selection drop-down list to change the
log settings for all of the log categories.
disable all logs (red X) - do not send the remote server logs for any log
category.
enable normal logs (green check mark) - send the remote server log
messages and alerts for all log categories.
enable normal logs and debug logs (yellow check mark) - send the
remote server log messages, alerts, and debugging information for all
log categories.
This field is a sequential value, and it is not associated with a specific
address.
This field displays each category of messages. It is the same value used
in the Display and Category fields in the View Log tab. The Default
category includes debugging messages generated by open source
software.
Chapter 44 Log and Report
691